Updating your kitchen or bathroom cabinets with modern cupboard handles can give them a fresh look. It’s a relatively easy home improvement project that you can do yourself, but there are a few safety tips you should follow to avoid any accidents.

Wear Safety Glasses

When working with power tools, it’s always important to wear safety glasses to protect your eyes from flying wood chips or drill bits. This is especially true when drilling into metal or wood, as the chips can be very sharp.

Use the Correct Drill Bit

The size of the drill bit you use will depend on the size and type of cupboard handle you’re installing. Make sure to use a sharp drill bit that is the same size as the screws that come with the handles. A dull drill bit can cause the wood to split or the metal to bind.

Drill Slowly and Carefully

When drilling, always start slowly and gradually increase the speed. This will help to prevent the drill bit from binding or skipping. Be careful not to drill too deeply, as you could damage the cupboard or the wall behind it.

Use Pilot Holes

Drilling pilot holes before inserting the screws will help to keep the wood from splitting. To drill a pilot hole, use a drill bit that is slightly smaller than the screw you’re using.

Drive the Screws Carefully

Once you’ve drilled the pilot holes, you can insert the screws. Drive the screws in slowly and carefully, using a screwdriver or drill. Make sure to tighten the screws securely, but don’t overtighten them.

Test the Handles

Once you’ve installed the handles, test them to make sure they’re attached securely. Open and close the cupboard doors or drawers several times to make sure the handles don’t loosen or fall off.

By following these safety tips, you can avoid any accidents and ensure that your new cupboard handles are installed correctly.

Additional Tips

In addition to the safety tips above, here are a few additional tips to make the installation process easier:

Measure carefully before drilling. Make sure to measure the distance between the handles and the edge of the cupboard or drawer.

Use a level to ensure that the handles are installed evenly.

Use a magnetic screwdriver to help keep the screws in place.

Tighten the screws gradually. Don’t overtighten them, or you could damage the handles or the cupboard.

Relevant Recommendation

Online Service

INQUIRY